These sliders have been designed to provide unsurpassed protection for your Yamaha
FJR1300 in the unfortunate event of a fall or tip-over. Motivation frame sliders
They are designed and manufactured by a company that only makes frame sliders. Each
And every model is tested for slip and drop protection. They are hard but no
brittle and can also absorb a big impact. Sports drivers from all over the world who have
tested various models of our products on the track, all have given their approval
after experiencing firsthand the benefits of Motovation frame sliders.
Read all instructions before starting work! These frame sliders are designed
to fit specific engine mounts on your Yamaha FJR1300. This kit has left and
right parts (left and right while sitting on the bike). It is highly recommended that
consult your service manual before performing this installation. If you are
If you are unsure of the torque, consult your motorcycle manual or
http://www.motovationusa.com/torque.html for a quick reference guide.
Included in this kit:
2 x Left / Right Side Frame Sliders
2 x thicker aluminum spacers (left)
2 x slimmer aluminum spacers (right)
2 x Left / Right High Grade Aluminum Brackets
3 socket head screws m12 x 80 mm
1 x M12 x 70mm socket head screw
2 socket head screws m10 x 50 mm for sliders.
Tools needed:
Torque wrench
12mm Allen key for torque wrench
14mm socket
Phillips screwdriver
INSTRUCTIONS: Try to install one side at a time.
one)
Remove both side fairings.
Remove the original bolts from the left side. Leave the original washers in place.
Install the supplied spacers as shown:
Left side spacers x 2 pieces (thicker).
Right side spacers x 2 pieces (thinner).
two)
Install left side bracket with thicker spacers as shown.
Tighten to the manufacturer’s recommended torque. (40 ft / lbs)
Using the supplied M12 x 80mm bolts.
3)
Remove the original bolts from the right side. Leave the original washers in place.
Install right side bracket with thinner spacers as shown
Tighten to the manufacturer’s recommended torque. (40 ft / lbs)
Use the supplied 1 x M12 x 70mm bolt for the top location.
Use the supplied 1 x M12 x 80mm bolt for the bottom location.
4)
Reinstall the left and right fairings in their original locations. This will leave alone
mounting locations for frame sliders visible on both sides.
5)
Install supplied frame sliders with remaining bolts and tighten.
Do not over-tighten.